Page 1 of 1

They arrived eventually

Posted: Thu Nov 17, 2022 4:12 pm
by Bastelhannes
Just only after a few months waiting the new cameras for tets arrived:

IMX334 and IMX545, both mono.
Cams.jpg
Cams.jpg (78 KiB) Viewed 330 times


As soon as I can test them I will post the results.

Re: They arrived eventually

Posted: Wed Nov 23, 2022 2:29 pm
by Bastelhannes
Okay, they do not work. Sharpcap does not support Basler anymore.....

Re: They arrived eventually

Posted: Wed Nov 23, 2022 3:07 pm
by LauraMS
Firecapture does, if I remember correctly ...

Re: They arrived eventually

Posted: Wed Nov 23, 2022 4:45 pm
by rsfoto
Bastelhannes wrote: Wed Nov 23, 2022 2:29 pm Okay, they do not work. Sharpcap does not support Basler anymore.....
HI,

I do not have a Basler but here on the website

https://www.sharpcap.co.uk/sharpcap/cameras

they are listed.

Why not contact Robin and ask him what the problem could be ?

:roll:

Re: They arrived eventually

Posted: Wed Nov 23, 2022 7:16 pm
by SassySun
How about Genika Astro?

Re: They arrived eventually

Posted: Wed Nov 23, 2022 8:55 pm
by LauraMS
Genika Astro definitely works with Basler ... (at least the IMX174)

Re: They arrived eventually

Posted: Thu Nov 24, 2022 6:15 am
by Rusted
Perhaps there is a clue in "Use Pylon 6.1.3 or earlier."

Re: They arrived eventually

Posted: Thu Nov 24, 2022 7:26 am
by Bastelhannes
Robin decided against Basler with future version 4.1, therefore I have no hope that even Pylon 6.1.3 (yes, it works) will work in the future.

I never tried Genika Astro. Because it's licence is bounded to three cameras and I am testing a lot of cameras, it is not compatible to my requirements.

Re: They arrived eventually

Posted: Thu Nov 24, 2022 7:59 am
by LauraMS
License is no more limited to three cameras in Genika Astro. But you can use FireCapture as well, works with Basler.

Re: They arrived eventually

Posted: Thu Nov 24, 2022 3:19 pm
by Bastelhannes
I figured it out as well; Laura, thank you very much for the hint.

Genika works with Basler, not Touptek. Difficult then.

Firecapture... wow... Basler is supported, but does not run... seems to be a common problem when I look into the support forum.

Looks like we are stuck to the familiar sensors.